30274 EJECTOR FULL SIZE

The best advice I can give you is to keep changing parts until you find a solution that works for your gun and ammunition choice. This leads to situations where some people own Glock's that have weak or erratic ejection, don't perform the same with aftermarket parts like barrels, guide rods and so on. From firing pins to trigger springs, nothing keeps your Glock running like OEM parts. What this means is you can have two guns that are the same make, model and firing the same ammunition and yet both pistols perform differently. Glock OEM parts and accessories are made with the same attention to detail and quality as the ultra-reliable pistols. It is my opinion that current Glock's suffer from a tolerance stacking problem. I could not buy the 30274 ejector online at the time and was left with the option of sending my pistol into Glock for repair. Ill find out for sure when Im installing the Apex extractor. Going off the basis that its a newer gun, my guess is that is also has the new spring loaded bearing. When you are using the 9mm barrel, while many people are able to use the 9mm barrels without swapping extractors and ejectors, sometimes it is necessary to make the swap to a 9mm extractor or 9mm ejector or even both. 30274 Ejector In Gen 3 I just purchased a gen 5 ejector and a gen 5 extractor for my gen 4 34. Checked my Glock before ordering and yes it does have the 30274 ejector since its less than a year old.

If your gun is a Gen 3 you might want to consider switching to the #28926 ejector. Glock Trigger Housing Fits Gen 3 Oem Ejector 30274 Ejection Fix Polymer80 P80. Im gonna be talking about a 30274 ejector, which is mid to late Gen Fours.

30274 EJECTOR FULL SIZE

If your 35 is a Gen 4 the ejector is going to be a #28926 If it is a Gen 3 the ejector should be #1882. Have a 30274 ejector and gen 4 housing otw so the question is do I modify the gen 4 housing to fit or just swap ejectors between housing. 416R Stainless Steel, Cerakoted Heat Treated to 37-44 on the Rockwell C scale Fits Glock Gen 1-3, Polymer80 PF940v2 Full Size G17 Front & Rear Serrations with Side and Top Ports Pre-Cut for Trijicon RMR mounting slot, plus factory front and.